======================================================
             =  Assembly steps and tips, for the Bally Astrocade  =
             =   Intended for internal uses by Ward Shrake only   =
             =            Last updated: Dec 13, 2002              =
             ======================================================


(1)   RED       Both wires, both ends. (7432 end first, then EPROM end.)

(2)   YELLOW    Both wires, both ends. (7432 end first, then ERPOM end.)

(3)   BROWN     (On other side.)  Bottom only, DIP end first, go to 3rd down.
(4)   BROWN     (On other side.)  Top only, DIP end first, go to 2nd down.

(5)   BLACK     Top only (1st down / solder line), DIP end first, then 7432.

(6)   GREEN     Top wire only, both ends; DIP end, then EPROM (5th down).
(7)   GREEN     Bottom wire only, both ends; DIP end, bend upwards, 4th down.

(8)   BLUE      Both wires, DIP end only.
(9)   BLUE      Bottom only, attach EPROM end. (2nd pin down, or solder line.)
(10)  BLUE      Top only, attach EPROM end. (3rd pin down, through hole.)

(11)  BLACK     Bottom only (2nd down at DIP), DIP end first, then 7432 end.



        Notes: This is all about the final jumper wire routing, which
        is found on the backside of the Bally multicart's PC board.
        "Bottom" and "Top" are references that relate to a position 
        near the DIP switches, with the rear side / card edge facing you.


Jumper wire's approximate "cut" lengths. (Conservative, with plenty left over)
=========================================================================

RED             7.0 cm      

YELLOW          8.5 cm

BROWN           5.5 cm          (Was originally the PURPLE wires)

BLACK           12 cm

GREEN           5.5 cm          (Was originally the WHITE wires)

BLUE            9.0 cm